1. Troubleshooting

Investigating the Cause of Cutting Failures

The machine cuts a sample stored in the unit to troubleshoot problems when data cannot be cut properly.

Executing a sample cut will clear any data saved in the receive buffer.

  1. Press the [FUNCTION] key in local mode.
  1. Use up jog_ down jog_ to select [SAMPLE CUT], then press the [ENTER/HOLD] key.
  1. Use up jog_ down jog_ to select the sample data.
  • There are two sample types: "Cut" and "LOGO".
  • If "Cut" is selected, proceed to Step 5.

Sample

Cut

LOGO

Cut sample figure 1

Cut sample figure 2

  1. When cutting with "LOGO" selected, press left jog_right jog_ to specify the scaling factor (1 to 999 %).
  1. Press the [ENTER/HOLD] key to start cutting.
  • Cutting starts.

Sample Cut Results

  • Sample data can be cut properly, but not other data.
    • There is a problem with the host computer.
  • Sample data as well as other data cannot be cut properly. (When the start/end points remain uncut)